Pressure Washing in Lapel & Central Indiana

The right pressure for the surface, every time

Pressure washing is high-pressure water, usually 2,500 to 3,500 PSI, run through a surface cleaner attachment that spins two jets in a flat, even pattern across the concrete. That even pattern matters: a wand held by hand at the wrong angle leaves visible zebra stripes in the finish. Concrete can take that pressure because it's hard and non-porous, which is exactly why we never use this method on siding, roofs, or wood, those need a soft wash instead.

Poured concrete, stamped concrete, exposed aggregate, and paver patios all clean up differently. Stamped and aggregate surfaces have more texture to trap dirt and need a slower pass; plain broom-finish concrete cleans faster. Oil stains, rust spots, and tire marks get a degreaser pre-treatment before we ever turn on the machine, which lifts far more than pressure alone ever would.

Central Indiana's two busiest pressure washing seasons are spring, when winter road salt residue and pollen have built up a dull film, and fall, before leaf tannins stain concrete for the whole winter. We do avoid deep-winter washing when temperatures hover near freezing, since water can work into small existing cracks and refreeze; a 40°F day or warmer is the safer call.

• Surface cleaner attachment for even results, no stripes
• Oil, rust & tire stains pre-treated before washing
• PSI matched to your concrete, not maxed out by default
• Priced by total square footage, one flat number up front